Nissan Altima 2007-2012 Service Manual: Heater & air conditioning system
- On-vehicle maintenance
- On-vehicle repair
- Refrigeration system
- Compressor
- Low-pressure flexible hose
- Low-pressure pipe
- High-pressure flexible hose
- High-pressure pipe
- Condenser
- Ambient sensor
- Refrigerant pressure sensor
- Expansion valve
- Service data and specifications (SDS)
Rear floor ducts
Removal and Installation
REMOVAL
1. Remove the floor carpet. Refer to INT-19, "Removal and Installation".
2. Remove the rear floor duct (RH, LH) clips.
3. Remove the rear floor ducts ...
Other materials:
Basic inspection
COMPONENT INSPECTION
Inspection
AFTER A COLLISION
WARNING:
Inspect all seat belt assemblies including retractors and attaching hardware
after any collision.
NISSAN/INFINITI recommends that all seat belt assemblies in use during a
collision be replaced
unless the collision was minor and t ...
B210a steering lock condition switch
Description
There are 2 switches in the steering unit. IPDM E/R compares those 2 switches
conditions to judge the
present steering status and transmit the result to BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210A is displayed with DTC U1000, first perform the ...
Front wiper auto stop signal circuit
Component Function Check
1. CHECK FRONT WIPER (AUTO STOP) OPERATION
1. Select "FRONT WIPER STOP" of IPDM E/R DATA MONITOR item.
2. Operate the front wiper.
3. With the front wiper operation, check the monitor status.
Is the status of item normal?
YES >> Auto stop signal ...