Nissan Altima 2007-2012 Service Manual: Security control system sedan with intelligent key
- Basic inspection
- Function diagnosis
- Intelligent key system/engine start function
- NVIS (Nissan vehicle immobilizer system-nats)
- Vehicle security system
- Diagnosis system (BCM)
- Component diagnosis
- U1000 can comm circuit
- U1010 control unit (can)
- B2013 ID discord, immu-strg
- B2014 chain of strg-immu
- B2108 steering lock relay
- B2109 steering lock relay
- B210a steering lock condition switch
- B210b starter control relay
- B210C starter control relay
- B210D starter relay
- B210E starter relay
- B210F PNP/clutch interlock switch
- B2110 PNP/clutch interlock switch
- B2190, P1610 nats antenna AMP
- B2191, P1615 difference of key
- B2192, P1611 ID discord, IMMU-ECM
- B2193, P1612 chain of ECM-IMMU
- B2555 stop lamp
- B2556 push-button ignition switch
- B2557 vehicle speed
- B2560 starter control relay
- B2601 shift position
- B2602 shift position
- B2603 shift position status
- B2604 PNP switch
- B2605 PNP switch
- B2606 steering lock relay
- B2607 steering lock relay
- B2608 starter relay
- B2609 steering status
- B260B steering lock unit
- B260C steering lock unit
- B260D steering lock unit
- B260F engine status
- B2612 Steering status
- B2617 Starter relay circuit
- B2619 BCM
- B261A push-button ignition switch
- B26E1 No reception of engine status signal
- POWER supply and ground circuit
- Key slot
- Key slot illumination
- Key cylinder switch
- Horn
- Headlamp
- Warning lamp
- Vehicle security indicator
- Ecu diagnosis
- Symptom diagnosis
- Intelligent key system/engine start function symptoms
- Vehicle security system symptoms
- Nissan vehicle immobilizer systemnats symptoms
- On-vehicle repair
Push button ignition switch
Removal and Installation
REMOVAL
1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and
Installation".
2. Release the pawls (A) and remove the push-button ignition
switch ...
Basic inspection
...
Other materials:
Forward-facing child restraint installation using LATCH
Refer to all Warnings and Cautions in the “Child
Safety” and “Child Restraint” sections before installing
a child restraint.
Follow these steps to install a forward-facing
child restraint using the LATCH system:
1. Position the child restraint on the seat. Always
follow the child res ...
Disassembly and assembly
FRONT DRIVE SHAFT
Disassembly and Assembly (Left Side)
1. Circlip
2. Dust shield
3. Slide joint housing
4. Snap ring
5. Spider assembly
6. Stopper ring
7. Boot band
8. Boot
9. Shaft
10. Damper band
11. Damper
12. Boot band
13. Boot
14. Ball cage / Steel ball / Inner race assembly
...
DLC branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the data link connector for damage,
bend and loose connection
(connector side and harness side) ...