Nissan Altima 2007-2012 Service Manual: Lan system can fundamental

On-vehicle rep
BCM (BODY CONTROL MODULE) Removal and Installation REMOVAL CAUTION: Before replacing BCM, perform "READ CONFIGURATION" to save or print current vehicle specification. Refer to BCS-5 ...

Precaution
Precautions for Trouble Diagnosis CAUTION: • Never apply 7.0 V or more to the measurement terminal. • Use a tester with open terminal voltage of 7.0 V or less. • Turn the ignition switch ...

Other materials:

On-vehicle repair
INSTRUMENT PANEL ASSEMBLY Exploded View 1. Center speaker grille 2. Tweeter speaker grille (LH) 3. Instrument panel 4. Instrument side mask (LH) 5. Combination meter 6. Lower knee protector (LH) 7. Cluster lid A 8. Instrument lower cover (LH) 9. Fuse block cover 10. Steering column cov ...

B2608 starter relay
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2608 is displa ...

Front fog lamp circuit
Description The IPDM E/R (intelligent power distribution module engine room) controls the front fog lamp relay based on inputs from the BCM over the CAN communication lines. When the front fog lamp relay is energized, power flows from the front fog lamp relay in the IPDM E/R to the front fog ...