Nissan Altima 2007-2012 Service Manual: A-BAG branch line circuit

Diagnosis Procedure

1.CHECK AIR BAG DIAGNOSIS SENSOR UNIT

Check the air bag diagnosis sensor unit. Refer to SRC-3, "Work Flow".

Is the inspection result normal? YES >> Replace the main harness.

NO >> Replace parts whose air bag system has a malfunction.

    ECM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and co ...

    BCM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    Other materials:

    Magnet clutch
    Description SYSTEM DESCRIPTION Front air control controls A/C compressor operation by ambient temperature and signal from ECM. Low Temperature Protection Control Front air control will turn the A/C compressor ON or OFF as determined by a signal detected by ambient sensor. When ambient te ...

    Compression pressure
    On-Vehicle Service CHECKING COMPRESSION PRESSURE 1. Run the engine until it reaches normal operating temperature. 2. Turn the ignition switch to OFF. 3. Release fuel pressure and leave the fuel pump electrically disconnected. Refer to EC-1579, "Inspection". 4. Remove all six ...

    Reprogramming a single HomeLink® button
    To reprogram a HomeLink® Universal Transceiver button, complete the following: 1. Press and hold the desired HomeLink® button. DO NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink® button, proceed with “Programming HomeL ...