Nissan Altima (L32) 2007-2012 Service Manual: Air cleaner filter
Removal and Installation
1. Air duct hose
2. Duct sub-cover
3. Front air duct
4. Air cleaner case (lower)
5. Grommets
6. Air cleaner case mounting bracket
7. Bracket
8. Air cleaner filter
9. Air cleaner case (upper)
10. Mass air flow sensor
A. To electric throttle control actuator
B. Air cleaner case side clips
CHANGING THE AIR CLEANER FILTER
CAUTION: It is not necessary to remove the front air duct to replace the ail cleaner filter.
1. Unhook the air cleaner case side clips.
2. Remove the air cleaner filter.
3. Install a new air cleaner filter.
4. Lock the air cleaner case side clips.
Fuel lines
Inspection Inspect fuel lines, filler cap and tank for improper attachment, leaks, cracks, damage, loose connections, chafing or deterioration. If necessary, repair or replace damaged parts. ...Engine oil
Changing Engine Oil WARNING: • Be careful not to burn yourself, as the engine oil may be hot. • Prolonged and repeated contact with used engine oil may cause skin cancer; try to avoid dire ...Other materials:
B210C starter control relay
Description
Starter control relay, integrated in IPDM E/R, permits the starter relay
operation when in N or P position and
the steering is locked or unlocked. It is installed in parallel with the starter
relay.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210C is displayed with DTC U10 ...
Mode door motor
Removal and Installation
REMOVAL
1. Remove the combination meter. Refer to MWI-176, "Removal and
Installation".
2. Remove the BCM (2). Refer to BCS-96, "Removal and Installation".
NOTE:
The illustration is shown with the heater and cooling unit assembly
out of the ve ...
Throttle valve closed position learning
Description
Throttle Valve Closed Position Learning is a function of ECM to learn the
fully closed position of the throttle
valve by monitoring the throttle position sensor output signal. It must be
performed each time the harness connector
of electric throttle control actuator or ECM ...