Nissan Altima Owners Manual: Aluminum alloy wheels (if so equipped)
Wash the wheels regularly with a sponge dampened in a mild soap solution, especially during winter months in areas where road salt is used. If not removed, road salt can discolor the wheels.
CAUTION
Follow the directions below to avoid staining or discoloring the wheels:
● Do not use a cleaner that uses strong acid or alkali contents to clean the wheels.
● Do not apply wheel cleaners to the wheels when they are hot. The wheel temperature should be the same as ambient temperature.
● Rinse the wheel to completely remove the cleaner within 15 minutes after the cleaner is applied.
Glass
When cleaning the rear window, it may be easier
to clean if the high-mounted stop light (if so
equipped) is removed first.
Be careful when removing the high-mounted
stop light to reduce the ri ...
Chrome parts
Clean all chrome parts regularly with a nonabrasive
chrome polish to maintain the finish. ...
Other materials:
Power steering fluid
Inspection
FLUID LEVEL
• Check fluid level with engine stopped.
• Make sure that fluid level is between MIN and MAX.
• Fluid levels at HOT (A) and COLD (B) are different. Do not confuse
them.
CAUTION:
• The fluid level should not exceed the MAX line. Excessive
fluid will caus ...
Low tire pressure warning lamp
stays on
Low Tire Pressure Warning Lamp Stays On When
Ignition Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.CHECK BCM CONNECTORS
1. Turn ignition switch OFF.
2. Disconnect BCM harness connectors.
3. Check terminals for damage or loose connections.
Is the inspection result normal?
YES >> GO ...
Malfunction indicator lamp
Description
The Malfunction Indicator Lamp (MIL) is located on the combination
meter.
The MIL will light up when the ignition switch is turned ON without
the engine running. This is a bulb check.
When the engine is started, the MIL should go off. If the MIL remains
on, the on board diagno ...