Nissan Altima (L32) 2007-2012 Service Manual ≻ Lan system can ≻ Component diagnosis ≻ AV Branch line circuit

Nissan Altima (L32) 2007-2012 Service Manual: AV Branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the AV control unit for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of AV control unit.

2. Check the resistance between the AV control unit harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the AV control unit branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the AV control unit. Refer to AV-315, "AV CONTROL UNIT : Diagnosis Procedure".

Is the inspection result normal? YES (Present error)>>Replace the AV control unit. Refer to AV-437, "Removal and Installation".

YES (Past error)>>Error was detected in the AV control unit branch line.

NO >> Repair the power supply and the ground circuit.

A-bag branch line circuit

Diagnosis Procedure 1.CHECK AIR BAG DIAGNOSIS SENSOR UNIT Check the air bag diagnosis sensor unit. Refer to SRC-3, "Work Flow". Is the inspection result normal? YES >> Replace t ...

BCM branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors o ...

Other materials:

Tachometer
5 inch (13 cm) Type A (if so equipped) The tachometer indicates engine speed in revolutions per minute (rpm). Do not rev the engine into the red zone 1. 7 inch (18 cm) Type B (if so equipped) CAUTION When engine speed approaches the red zone, shift to a higher gear or reduce engine speed. Operati ...

Memory seat (if so equipped)
The memory seat system has three features: Memory storage function (Key-link) Memory storage function (Switch) Entry/exit function Key-link, when enabled, automatically retains the driver’s last seat and outside mirror position for that specific key when the ignition is turned from ON to OFF. ...

Operating ProPILOT Assist
Push the ProPILOT Assist switch A. This turns on the ProPILOT Assist system. A screen is displayed for a period of time that indicates the status of the driving aid functions. AEB with Pedestrian Detection, LDW, and BSW are enabled when the specified driving aid is shaded. I-LI is ...