Nissan Altima (L32) 2007-2012 Service Manual ≻ Lan system can system (type 2) ≻ AV branch line circuit

Nissan Altima (L32) 2007-2012 Service Manual: AV branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the AV control unit for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of AV control unit.

2. Check the resistance between the AV control unit harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the AV control unit branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the AV control unit. Refer to AV-315, "AV CONTROL UNIT : Diagnosis Procedure".

Is the inspection result normal? YES (Present error)>>Replace the AV control unit. Refer to AV-437, "Removal and Installation".

YES (Past error)>>Error was detected in the AV control unit branch line.

NO >> Repair the power supply and the ground circuit.

A-BAG branch line circuit

Diagnosis Procedure 1.CHECK AIR BAG DIAGNOSIS SENSOR UNIT Check the air bag diagnosis sensor unit. Refer to SRC-3, "Work Flow". Is the inspection result normal? YES >> Replace t ...

BCM branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

Other materials:

Trip computer
1. Vehicle speed The vehicle speed mode shows the current vehicle speed and the average vehicle speed since the last reset. Average vehicle speed: Press the OK button on the steering wheel to bring up the drive computer Reset menu, and follow the instructions to reset. For additional information, ...

Hood
Pull the hood lock release handle 1 located below the driver's side instrument panel; the hood springs up slightly. To open the hood, push the lever 2 underneath the front of the hood upwards with your fingertips as illustrated and raise the hood. Remove the support rod from the clamp 3. ...

Oil control system (if so equipped)
The oil control system can be accessed in the Maintenance portion of the vehicle information display settings. Engine oil information informs the distance to oil change. Never exceed one year or 7,500 miles (12000 km) between oil change intervals for the 2.0L 4 cylinder (KR20DDET engine model) or 1 ...