Nissan Altima (L32) 2007-2012 Service Manual: B2619 BCM
Description
BCM requests IPDM E/R to supply power to steering lock unit. After receiving
the power, the steering lock unit
transmits an ON signal to BCM.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Press the push-button ignition switch under the following conditions and
wait for at least 1 second.
- CVT selector lever is in the P position
- Do not depress brake pedal
2. Check “Self diagnostic result” with CONSULT-III.
Is DTC detected?
YES >> Refer to SEC-107, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Check “Self diagnostic result” with CONSULT-III.
3. Touch “ERASE”.
4. Perform DTC Confirmation Procedure.
See SEC-107, "DTC Logic".
Is the DTC B2619 displayed again?
YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".
NO >> Inspection End.
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal ...
Description
IPDM E/R transmits the push-button ignition switch status via CAN
communication to BCM. BCM receives
push-button ignition switch status by hardwire input. BCM compares the 2 signals
...
Other materials: Forward-facing child restraint
installation using the seat belts
WARNING
The three-point seat belt with Automatic
Locking Retractor (ALR) must be
used when installing a child restraint.
Failure to use the ALR mode will result
in the child restraint not being properly
secured. The restraint could tip over or
be loose and cause injury to a child in a
sudden stop o ...
Doors
When the doors are locked using one of the
following methods, the doors cannot be
opened using the inside or outside door
handles. The doors must be unlocked to
open the doors.
WARNING
Always have the doors locked while
driving. Along with the use of seat
belts, this provides greater safety in
...
System temporarily unavailable
Condition A:
The warning and assist functions of the I-LI
system are not designed to work under the
following conditions:
When you operate the lane change signal
and change the traveling lanes in the direction
of the signal. (The I-LI system
will be deactivated for approximately 2
seconds afte ...
B2617 starter relay circuit
B261a push-button ignition switch