Nissan Altima 2007-2012 Service Manual: Body construction

Body Construction

    Body sealing
    Description The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these areas should be smooth and free from cuts or gaps. Care should be taken no ...

    Body alignment
    Body Center Marks A mark has been placed on each part of the body to indicate the vehicle center. When repairing parts damaged by an accident which might affect the vehicle frame (members, pillar ...

    Other materials:

    Rear view monitor system (coupe)
    System Diagram System Description When the selector is in the R position, the display shows a view to the rear of the vehicle. Lines which indicate the vehicle clearance and distances are also displayed. AV COMMUNICATION LINE The rear view camera control unit is connected to the AV control ...

    Camshaft valve clearance
    Camshaft valve clearance • Perform this inspection as follows after removal, installation, or replacement of the camshaft or any valverelated parts, or if there are any unusual engine conditions due to changes in valve clearance over time (starting, idling, and/or noise). 1. Warm up the ...

    Can communication circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connectors on CAN communication system. 4. Check terminals and connectors for damage, bend and loose con ...