Nissan Altima (L32) 2007-2012 Service Manual ≻ Audio, visual & navigation system bose audio with navigation ≻ Component diagnosis ≻ Power supply and ground circuit (coupe) ≻ Bose speaker AMP

Nissan Altima (L32) 2007-2012 Service Manual: Bose speaker AMP

Diagnosis Procedure

1.CHECK FUSE

Check that the following fuses of the BOSE speaker amp. are not blown.

Are the fuses OK?

YES >> GO TO 2

NO >> Be sure to eliminate cause of malfunction before installing new fuse.

2.CHECK POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BOSE speaker amp connector.

3. Check voltage between BOSE speaker amp harness connector and ground.

Are the voltage readings as specified? YES >> GO TO 3

NO >> Check harness between BOSE speaker amp. and fuse.

3.CHECK GROUND CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BOSE speaker amp connector.

3. Check continuity between BOSE speaker amp harness connector and ground.

Are continuity test results as specified? YES >> Inspection End.

NO >> Repair harness or connector.

Rear view camera

Diagnosis Procedure 1.CHECK POWER SUPPLY CIRCUIT (REAR VIEW CAMERA SIDE) Check voltage between rear view camera harness connector and ground. Is voltage reading approximately 6 volts? YES &g ...

CD changer

Diagnosis Procedure 1.CHECK FUSE Check that the following fuses of the CD changer are not blown. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause of malfunction bef ...

Other materials:

Intelligent Around View Monitor system limitations
WARNING Listed below are the system limitations for Intelligent Around View Monitor. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death. Do not use the Intelligent Around View Monitor with the outside mirrors in the stored positio ...

Vehicle information display warnings and indicators
The following messages may appear in your vehicle information display. Place the key near the start switch This indicator appears when the battery of the Intelligent Key is low and when the Intelligent Key system and the vehicle are not communicating normally. If this appears, touch the ignition s ...

Trip computer
1. Home This display indicates the home screen. 2. Vehicle speed The vehicle speed mode shows the current vehicle speed and the average vehicle speed since the last reset. Average vehicle speed: Press and hold the OK button on the steering wheel to bring up the drive computer Reset menu, and follow ...