Nissan Altima Owners Manual: Control buttons

The control buttons for the Bluetooth® Hands-Free


The control buttons for the Bluetooth® Hands-Free Phone System are located on the steering wheel.

Press the  button to initiate a PHONE/SEND


Press the VR button to initiate a
VR session or answer an incoming call.

You can also use the interrupt the system feedback and button to
interrupt the system feedback and give a command at once. See “List of voice commands” and “During a call” in this section for more information.

While the Voice Recognition system is PHONE/END


While the Voice Recognition system is active, press and hold the for 5 seconds to quit the Voice button
for 5 seconds to quit the Voice Recognition system at any time.

While using the Voice Recognition ENTER button / tuning switch


While using the Voice Recognition system, tilt the tuning switch up or down to manually control the phone system. Press the ENTER button to select an option on the display screen.

    Using the system
    The NISSAN Voice Recognition system allows hands-free operation of the Bluetooth® Phone System. If the vehicle is in motion, some commands may not be available so full attention may be given to ...

    Getting started
    The following procedures will help you get started using the Bluetooth® Hands-Free Phone System with NISSAN Voice Recognition. For additional command options, refer to “List of voice commands ...

    Other materials:

    When reading the manual
    This manual includes information for all features and equipment available on this model. Features and equipment in your vehicle may vary depending on model, trim level, options selected, order, date of production, region or availability. Therefore, you may find information about features or eq ...

    Anti-pinch system does not operate normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-21, "POWER WINDOW MAIN SWITCH : Special Repair Requirement". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the malfunctioning parts. 2. C ...

    Accelerator pedal released position learning
    Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time harness connector of accelerator pedal position sensor ...