Nissan Altima (L32) 2007-2012 Service Manual ≻ Lan system can system (type 4) ≻ DLC branch line circuit

Nissan Altima (L32) 2007-2012 Service Manual: DLC branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

Check the resistance between the data link connector terminals.

Is the measurement value within the specification? YES (Present error)>>Check CAN system type decision again.

YES (Past error)>>Error was detected in the data link connector branch line circuit.

NO >> Repair the data link connector branch line.

BCM branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

M&A branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

Other materials:

Steering wheel
WARNING Do not adjust the steering wheel while driving. You could lose control of your vehicle and cause an accident. Do not adjust the steering wheel any closer to you than is necessary for proper steering operation and comfort. The driver's air bag inflates with great force. If you are un ...

Vehicle information display - 7 inch (18 cm) Type B (if so equipped)
The vehicle information display is located to the left of the speedometer. It displays such items as: Vehicle settings Indicators and warnings Information/warning messages Tire pressure information Drive computer information Cruise control system information Driving Aids (if so equipped) P ...

Hood
Pull the hood lock release handle 1 located below the driver's side instrument panel; the hood springs up slightly. To open the hood, push the lever 2 underneath the front of the hood upwards with your fingertips as illustrated and raise the hood. Remove the support rod from the clamp 3. ...