Nissan Altima (L32) 2007-2012 Service Manual ≻ Lan system can system (type 6) ≻ DLC branch line circuit

Nissan Altima (L32) 2007-2012 Service Manual: DLC branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

Check the resistance between the data link connector terminals.

Is the measurement value within the specification? YES (Present error)>>Check CAN system type decision again.

YES (Past error)>>Error was detected in the data link connector branch line circuit.

NO >> Repair the data link connector branch line.

BCM branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

M&A branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

Other materials:

Heater and air conditioner (manual) (if so equipped)
Fan speed control dial Heated seat switches (if so equipped) Front defroster button Rear window and outside mirror (if so equipped) defroster switch Air recirculation button MAX A/C / temperature control dial Air flow control buttons A/C (air conditioner) button WARNING The air ...

Regulatory information
FCC Regulatory information CAUTION: To maintain compliance with FCC’s RF exposure guidelines, use only the supplied antenna. Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC regulations. Operation is subject to the following two condition ...

Starting the engine
1. Apply the parking brake. 2. Move the shift lever to P (Park) or N (Neutral). P (Park) is recommended. The starter is designed not to operate if the shift lever is in any of the driving positions. 3. Push the ignition switch to the ON position. Depress the brake pedal and push the ignition swi ...