Nissan Altima 2007-2012 Service Manual: Door mirror
Exploded View
1. Nut
2. Mirror assembly
3. Door panel
Removal and Installation
REMOVAL
1. Remove the front door finisher. Refer to INT-12, "Removal and Installation".
2. Disconnect the door mirror harness connector.
3. Remove the door mirror mounting nuts, and remove the door mirror assembly.
INSTALLATION
Installation is in the reverse order of removal.
Inside mirror
Exploded View
1. Inside mirror
2. Inside mirror finisher (if equipped)
3. Mirror base
Removal and Installation
1. Remove inside mirror finisher (if equipped).
2. Remove screw of mirror bas ...
Disassembly and assembly
DOOR MIRROR
Exploded View
1. Door mirror cover
2. Mirror housing assembly
3. Mirror glass and holder
Disassembly
1. Turn the mirror glass surface upward.
2. Apply a protective tape (A) to ...
Other materials:
Normal operating condition
Description
FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED)
If the engine speed is above 1,400 rpm under no load (for example, the
selector lever position is P or N and
engine speed is over 1,400 rpm) fuel will be cut off after some time. The exact
time when the fuel is cut off varies
ba ...
On board refueling vapor recovery
(ORVR)
Description
From the beginning of refueling, the air and vapor inside the fuel tank go
through refueling EVAP vapor cut
valve and EVAP/ORVR line to the EVAP canister. The vapor is absorbed by the EVAP
canister and the air is
released to the atmosphere.
When the refueling has reached the ...
Idle speed
Description
This describes how to check the idle speed. For the actual procedure, follow
the instructions in “BASIC
INSPECTION”.
Special Repair Requirement
1.CHECK IDLE SPEED
Check idle speed in “DATA MONITOR” mode with CONSULT-III.
Check idle speed with Service $01 of GST.
> ...