Nissan Altima Owners Manual: Extending engine run time

The remote start feature can be extended one time by performing the steps listed in “Remote starting the vehicle” in this section. Run time will be calculated as follows: ● The first 10 minute run time will start when the remote start function is performed.

● The second 10 minutes will start immediately when the remote start function is performed.

For example, if the engine has been running for 5 minutes, and 10 minutes are added, the engine will run for a total of 15 minutes.

A maximum of two remote starts, or a single start with an extension, are allowed between ignition cycles.

The ignition switch must be cycled to the ON position and then back to the OFF position before the remote start procedure can be used again.

    Remote starting the vehicle
    perform the following: 1. Aim the Intelligent Key at the vehicle. 2. Press the LOCK button to lock all doors. 3. Within 5 seconds press and hold the remote start button until the turn si ...

    Canceling a remote start
    To cancel a remote start, perform one of the following: ● Aim the Intelligent Key at the vehicle and press and hold until the parking lights turn off. ● Turn on the hazard warning ...

    Other materials:

    Connecting procedure
    NOTE: The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled. To connect a phone to the Bluetooth® Hands- Free Phone System: 1. Press the SETTING button. 2. Use the TUNE/FOLDER knob to s ...

    Engine control system
    System Diagram System Description ECM performs various controls such as fuel injection control and ignition timing control. Component Parts Location 1. Intake valve timing control solenoid valve 2. Ignition coil (with power transistor) and spark plug 3. Knock sensor, Crankshaft posi ...

    B260d steering lock unit
    Description The electronic steering column lock performs the check by itself according to the steering lock status (before lock, after lock and unlock). DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Turn i ...