Nissan Altima 2007-2012 Service Manual: Front bumper

Removal and Installation

1. Front bumper supports

2. Front bumper side bracket

3. Reinforcement bracket

4. Front bumper reinforcement

5. Front energy absorbing foam

6. Front bumper fascia

7. Tow hook cover

8. Front grille

9. License plate bracket

10. Fog lamp finisher (if equipped)

11. Fog lamp (if equipped)

A. Clip C101

REMOVAL

1. Remove the front fender protectors RH and LH. Refer to EXT-19, "Removal and Installation".

2. Remove the engine under cover.

3. Remove the RH and LH side under covers.

4. Remove the fog lamp if equipped. Refer to EXL-256, "Removal and Installation".

5. Remove the front bumper fascia clips and screws, then remove the front bumper fascia.

6. Remove the front grille. Refer to EXT-17, "Removal and Installation".

7. Remove the front energy absorbing foam.

8. Remove the front bumper reinforcement and reinforcement bracket.

9. Remove the front bumper supports.

INSTALLATION

Installation is in the reverse order of removal.

    Rear bumper
    Removal and Installation 1. Rear bumper side brackets 2. Rear bumper supports 3. Rear bumper reinforcement 4. Rear energy absorbing foam 5. Rear bumper fascia A. C205 push pin REMOVAL 1. R ...

    Other materials:

    B2562 low voltage
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. DTC CONFIRMATION 1. Erase DTC. 2. Turn ignition switch OFF. 3. Perform the "SELF-DIAG RESULTS" of CONSULT-III, after the ignition switch has been turned ON for 1.5 seconds or more. Is any DTC detected? YES >& ...

    Ecu diagnosis
    ECM Reference Value VALUES ON THE DIAGNOSIS TOOL Remarks: ● Specification data are reference values. ● Specification data are output/input values which are detected or supplied by the ECM at the connector. ● Specification data may not be directly related to their com ...

    Tweeter (sedan)
    Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the front tweeters using the audio signal circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect BOSE speaker amp. connector B122 and suspe ...