Nissan Altima 2007-2012 Service Manual: Front regulator
Exploded View
1. Door
2. Inside seal
3. Door glass
4. Regulator assembly
5. Door module assembly
6. Window motor
Disassembly
Remove the window motor nuts (A) the four window regulator bolts (B) and the window motor (1) from the door module assembly. On the back side remove the window regulator from the door module assembly.
Assembly
Assembly is in the reverse order of disassembly.
Rear regulator
Exploded View
1. Rear door
2. Door glass run
3. Door glass
4. Inside seal
5. Partition sash
6. Door rear glass seal
7. Door rear glass
8. Regulator assembly
9. Window motor
10. Water shiel ...
Other materials:
P2100, P2103 throttle control motor
relay
Description
Power supply for the throttle control motor is provided to the ECM via
throttle control motor relay. The throttle
control motor relay is ON/OFF controlled by the ECM. When the ignition switch is
turned ON, the ECM sends
an ON signal to throttle control motor relay and battery vol ...
Line pressure test
Inspection and Judgment
INSPECTION
Line Pressure Test Port (A)
Line Pressure Test Procedure
1. Inspect the amount of engine oil and replenish if necessary.
2. Drive the car for about 10 minutes to warm it up so that the CVT fluid
reaches in the range of 50 to 80°C
(122 to 176°F), then ...
B2616 ignition relay circuit
Description
BCM controls the various electrical components and simultaneously supplies
power according to the power
supply position.
BCM checks the power supply position internally.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1. PERFORM DTC CONFIRMATION PROCEDURE
1. Turn i ...