Nissan Altima Owners Manual: Hood
1 Pull the hood lock release handle located below the driver’s side instrument panel; the hood springs up slightly.
2 Push the lever at the front of the hood to the side as illustrated with your fingertips and raise the hood.
3 Remove the support rod from the clamp.
4 Insert the support rod into the slot on the passenger side fender ledge.
5. When closing the hood, return the support rod to its original position, lower the hood to approximately 30 cm (12 in) above the latch and release it. This allows proper engagement of the hood latch.
WARNING
● Make sure the hood is completely closed and latched before driving. The vehicle should only ever be operated with the hood securely closed.
● If you see steam or smoke coming from the engine compartment, to avoid injury do not open the hood.
Conditions the remote start will not work
The remote start will not operate if any of the
following conditions are present:
● The ignition switch is placed in the ON position.
● The hood is not securely closed.
● The haz ...
Trunk lid
...
Other materials:
B2612 steering status
Description
There are 2 switches in the electronic steering column lock. IPDM E/R
compares those 2 switches conditions
to judge the present steering status and transmit the result to BCM via CAN
communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2612 is displayed with DTC U10 ...
Information display
System Diagram
System Description
FUNCTION
The information display can indicate the following items.
• Outside air temperature
• Trip/fuel consumption readings
• Intelligent Key operation information
• Maintenance information
• Warning/Indication messages (Door ajar, low fuel, ...
P1553 Battery current sensor
Description
The power generation voltage variable control enables fuel consumption to
be decreased by reducing the
engine load which is caused by the power generation of the generator. The
battery current sensor is installed
to the battery cable at the negative terminal. The sensor measures t ...