Nissan Altima (L32) 2007-2012 Service Manual: In-cabin microfilter
Removal and Installation
REMOVAL
1. Remove the glove box assembly. Refer to IP-12, "Removal and Installation".
2. Disengage the filter cover tab (1) to remove the filter cover.
3. Remove the in-cabin microfilter from the blower unit by using the
pull tab on the bottom of the filter.
INSTALLATION
Installation is in the reverse order of removal.
Inspection
Check exhaust pipes, muffler and mounting for improper attachment,
leaks, cracks, damage, chafing or deterioration.
• If anything is found, repair or replace damaged parts.
...
Other materials: Heater operation
Heating
This mode is used to direct heated air to
the foot outlets. Some air also flows from
the defrost outlets and the side vent
outlets.
1. Press thebutton to the off
position
for normal heating.
2. Press theair flow control
button.
3. Turn thefan speed control dial
to
the desired position.
...
NISSAN Vehicle Immobilizer System
The NISSAN Vehicle Immobilizer System
will not allow the engine to start without
the use of a registered key.
If the engine fails to start using a registered
key (for example, when interference is
caused by another registered key, an automated
toll road device or automatic payment
device on the key ...
Hill start assist system
WARNING
Never rely solely on the hill start assist
system to prevent the vehicle
from moving backward on a hill. Always
drive carefully and attentively.
Depress the brake pedal when the
vehicle is stopped on a steep hill. Be
especially careful when stopped on a
hill on frozen or muddy roads ...
Chassis and body maintenance
Exhaust system