Nissan Altima 2007-2012 Service Manual: Inspection and adjustment

ECM RE-COMMUNICATING FUNCTION

Description

Performing following procedure can automatically perform re-communication of ECM and BCM, but only when the ECM has been replaced with a new one (*1).

*1: New one means an ECM which has never been energized on-board.

(In this step, initialization procedure by CONSULT-III is not necessary) NOTE: • When registering new Key IDs or replacing the ECM that is not brand new, refer to CONSULT-III Operation Manual.

• If multiple keys are attached to the key holder, separate them before work.

• Distinguish keys with unregistered key ID from those with registered ID.

Special Repair Requirement

1.PERFORM ECM RE-COMMUNICATING FUNCTION

1. Install ECM.

2. Insert the registered Intelligent Key (*2), turn ignition switch to “ON”.

*2: To perform this step, use the key that has been used before performing ECM replacement.

3. Maintain ignition switch in “ON” position for at least 5 seconds.

4. Turn ignition switch to “OFF”.

5. Start engine.

Can engine be started? YES >> Procedure is completed.

NO >> Initialize control unit. Refer to CONSULT-III Operation Manual.

    Pre-inspection for diagnostic
    Basic Inspection The engine start function, door lock function, power distribution system and NATS-IVIS/NMS in the Intelligent Key system are closely related to each other regarding control. Narr ...

    Other materials:

    Antenna AMP
    Removal and Installation - Coupe REMOVAL 1. Remove the rear pillar finisher RH. Refer to INT-20, "Exploded View". 2. Detach the antenna amp harness clip (B), disconnect the antenna amp connectors (A), remove the antenna amp screw (C) and remove the antenna amp (1). NSTALLATION ...

    On-vehicle maintenance
    WHEEL HUB On-vehicle Service Check axle and suspension parts for excessive play, wear or damage. • Shake each rear wheel to check for excessive play. Rear Wheel Bearing • Check axial end play. Axial end play : 0.1 mm (0.004 in) or less • Check that wheel hub bearings operate smooth ...

    Bluetooth control unit
     Diagnosis Procedure 1.CHECK FUSE Check that the following fuses of the Bluetooth control unit are not blown. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause of malfunction before installing new fuse. 2.CHECK POWER SUPPLY CIRCUIT Check voltage between Blue ...