Nissan Altima (L32) 2007-2012 Service Manual ≻ Lan system can system (type 6) ≻ IPDM-E branch line circuit

Nissan Altima (L32) 2007-2012 Service Manual: IPDM-E branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the IPDM E/R for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of IPDM E/R.

2. Check the resistance between the IPDM E/R harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the IPDM E/R branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the IPDM E/R. Refer to PCS-23, "Diagnosis Procedure" .

Is the inspection result normal? YES (Present error)>>Replace the IPDM E/R. Refer to PCS-48, "Removal and Installation".

YES (Past error)>>Error was detected in the IPDM E/R branch line.

NO >> Repair the power supply and the ground circuit.

ABS branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

Can communication circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connect ...

Other materials:

Programming trouble-diagnosis
If the HomeLink does not quickly learn the hand-held transmitter information: Replace the hand-held transmitter batteries with new batteries. Position the hand-held transmitter with its battery area facing away from the HomeLink surface. Press and hold both the HomeLink and hand-held transmi ...

Continuously Variable Transmission (CVT)
WARNING Do not depress the accelerator pedal while shifting from P (Park) or N (Neutral) to R (Reverse), D (Drive), L (Low) or manual shift mode (if so equipped). Always depress the brake pedal until shifting is completed. Failure to do so could cause you to lose control and have an acciden ...

Forward-facing child restraint installation using the seat belts
WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a child in a sudden stop o ...