Nissan Altima (L32) 2007-2012 Service Manual ≻ Lan system can system (type 10) ≻ IPDM-E branch line circuit

Nissan Altima (L32) 2007-2012 Service Manual: IPDM-E branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the IPDM E/R for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of IPDM E/R.

2. Check the resistance between the IPDM E/R harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the IPDM E/R branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the IPDM E/R. Refer to PCS-23, "Diagnosis Procedure" .

Is the inspection result normal? YES (Present error)>>Replace the IPDM E/R. Refer to PCS-48, "Removal and Installation".

YES (Past error)>>Error was detected in the IPDM E/R branch line.

NO >> Repair the power supply and the ground circuit.

ABS branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

Can communication circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connect ...

Other materials:

Hood
Pull the hood lock release handle 1 located below the driver's side instrument panel; the hood springs up slightly. To open the hood, push the lever 2 underneath the front of the hood upwards with your fingertips as illustrated and raise the hood. Remove the support rod from the clamp 3. ...

Air conditioner operation
Start the engine, turn thefan speed control dial to the desired position, and press thebutton to activate the air conditioner. When the air conditioner is on, cooling and dehumidifying functions are added to the heater operation. The air conditioner cooling function operates only when the engine i ...

MOD system operation
The MOD system will turn on automatically under the following conditions: When the shift lever is in the R (Reverse) position. When the CAMERA button is pressed to activate the camera view on the display. When vehicle speed decreases below approximately 6 mph (10 km/h) and the camera screen ...