Nissan Altima 2007-2012 Service Manual: Key slot

Removal and Installation

REMOVAL

1. Remove the instrument lower panel LH. Refer to IP-12, "Removal and Installation".

2. Disconnect key slot connector.

3. Remove the key slot screw (A), and then remove key slot (1) from instrument lower panel LH (2).

INSTALLATION

Installation is in the reverse order of removal.

    Push button ignition switch
    Removal and Installation REMOVAL 1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and Installation". 2. Release the pawls (A) and remove the push-button ignition switch ...

    Other materials:

    Vin registration
    Description VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced. NOTE: Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M) VIN REGISTRATION : Special Repair Requirement 1.CHECK VIN Check th ...

    Cylinder block
    Disassembly and Assembly 1. Cylinder block 2. O-ring 3. Crankshaft position sensor (POS) 4. Knock sensor 5. Cylinder block heater (if equipped) 6. Lower cylinder block 7. Lower cylinder block bolt 8. Snap ring 9. Connecting rod 10. Connecting rod bearing 11. Connecting rod bearing cap ...

    DLC branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side) ...