Nissan Altima (L32) 2007-2012 Service Manual ≻ Lan system can system (type 7) ≻ M&A branch line circuit

Nissan Altima (L32) 2007-2012 Service Manual: M&A branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the combination meter for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of combination meter.

2. Check the resistance between the combination meter harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the combination meter branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the combination meter. Refer to MWI-43, "COMBINATION METER : Diagnosis Procedure".

Is the inspection result normal? YES (Present error)>>Replace the combination meter. Refer to MWI-176, "Removal and Installation".

YES (Past error)>>Error was detected in the combination meter branch line.

NO >> Repair the power supply and the ground circuit.

DLC branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors o ...

ABS branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

Other materials:

Starting the vehicle
1. After starting the engine, fully depress the foot brake pedal before moving the shift lever out of the P (Park) position. The Continuously Variable Transmission is designed so the foot brake pedal MUST be depressed before shifting from P (Park) to any drive position while the ignition switch is i ...

Moving Object Detection (MOD) (if so equipped)
CAMERA button WARNING Failure to follow the warnings and instructions for proper use of the Moving Object Detection (MOD) system could result in serious injury or death The MOD system is not a substitute for proper vehicle operation and is not designed to prevent contact with objects surrou ...

Trip computer
1. Home This display indicates the home screen. 2. Vehicle speed The vehicle speed mode shows the current vehicle speed and the average vehicle speed since the last reset. Average vehicle speed: Press and hold the OK button on the steering wheel to bring up the drive computer Reset menu, and follow ...