Nissan Altima 2007-2012 Service Manual: Main line between dlc and abs circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side).
- Harness connector M1
- Harness connector E30
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair the terminal and connector.
2.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
1. Disconnect the harness connectors M1 and E30.
2. Check the continuity between the data link connector and the harness connector.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair the main line between the data link connector and the harness connector M1.
3.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
1. Disconnect the connector of ABS actuator and electric unit (control unit).
2. Check the continuity between the harness connector and the ABS actuator and electric unit (control unit) harness connector.
Is the inspection result normal? YES (Present error)>>Check CAN system type decision again.
YES (Past error)>>Error was detected in the main line between the data link connector and the ABS actuator and electric unit (control unit).
NO >> Repair the main line between the harness connector E30 and the ABS actuator and electric unit (control unit).
Malfunction area chart
Main Line
Branch Line
Short Circuit
...
ECM branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and co ...
Other materials:
Lan system circuit
Description
SYMPTOM: Mode door motor, intake door motor and/or air mix door motor does
not operate normally.
Diagnosis Procedure
DIAGNOSIS PROCEDURE FOR LAN CIRCUIT
1.CHECK POWER SUPPLY FOR DOOR MOTORS
1. Press ignition switch ON.
2. Check voltage between front air control connector M37 ...
P0011 IVT control
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P0011 is displayed with DTC P0075, first perform the trouble diagnosis
for EC-362, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn
ignition switch OFF a ...
Front power window switch
Description
• BCM supplies power.
• Front power window motor RH will be operated if power window and door
lock/unlock switch RH is operated.
Component Function Check
Power Window And Door Lock/unlock Switch RH
1. CHECK POWER WINDOW MOTOR FUNCTION
Does front power window motor operate w ...