Nissan Altima (L32) 2007-2012 Service Manual: Memory function does not operate
Diagnosis Procedure
SYMPTOM: Memory function does not operate. The setting is not maintained (it
returns to the initial condition).
Inspection procedure
1.CHECK OPERATION
1. Set temperature control dial to 32°C (90°F).
2. Press OFF switch.
3. Press ignition switch OFF.
4. Press ignition switch ON.
5. Press AUTO switch.
6. Check that the set temperature is maintained.
Is the inspection result normal?
YES >> Inspection End.
NO >> GO TO 2.
2.CHECK POWER SUPPLY AND GROUND CIRCUIT OF FRONT AIR CONTROL
Check power supply and ground circuit of front air control. Refer to HAC-61,
"Diagnosis Procedure".
Is the inspection result normal?
YES >> Replace front air control. Refer to VTL-8, "Removal and Installation".
NO >> Repair or replace malfunctioning part(s).
Diagnosis Procedure
SYMPTOM: Self-diagnosis cannot be performed.
1.CHECK SELF-DIAGNOSIS FUNCTION
1. Press ignition switch ON.
2. Set in self-diagnosis mode as follows. Within 10 seconds after s ...
Supplemental Restraint System (SRS) "AIR BAG"
and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used alo ...
Other materials: 2.5L 4 cylinder (PR25DD engine model)
The following shows the maintenance
schedule.
Choose the maintenance schedule
needed based on your vehicle driving
conditions.
After 120,000 miles (192,000 km)/144
months, continue maintenance at the
same mileage/time interval.
5,000 miles/(8,000 km)/6 months
Perform at number of miles, kilometers ...
Brake system
The brake system has two separate hydraulic
circuits. If one circuit malfunctions,
you will still have braking at two wheels.
Brake precautions
Vacuum assisted brakes
The brake booster aids braking by using
engine vacuum. If the engine stops, you
can stop the vehicle by depressing the
brake pedal. H ...
System maintenance
The two radar sensors 1 for the BSW and
RCTA systems are located near the rear
bumper. Always keep the area near the radar
sensors clean.
The radar sensors may be blocked by temporary
ambient conditions such as splashing
water, mist or fog.
The blocked condition may also be caused
by objects such ...