Nissan Altima (L32) 2007-2012 Service Manual: Nissan vehicle immobilizer systemnats symptoms
Symptom Table
Security indicator does not turn ON or flash.
CAUTION: • Follow Trouble Diagnosis Flowchart referring to “SEC-411, "Work Flow"”. Determine malfunctioning condition before performing this diagnosis.
• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis.
• Check systems shown in the “Action” column in this order.
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
• Keyfob is not inserted into key slot.
• Engine switch is not depressed.
Vehicle security system symptoms
Symptom Table *: Check that the system is in the armed phase. ...Other materials:
Body sealing
Description
The following figure shows the areas which are sealed at the factory. Sealant
which has been applied to these
areas should be smooth and free from cuts or gaps. Care should be taken not to
apply an excess amount of
sealant and not to allow other unaffected parts to come into conta ...
B26E1 No reception of engine status
signal
Description
BCM receives the engine status signal from ECM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B26E1 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
SEC-235, "DTC Logic".
• If DTC B26E1 is displayed wi ...
Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions thatexist
when the noise occurs. Use the Diagnostic
Worksheet during the interviewto document the facts and conditions when the
noise occurs and any
customer's ...