Nissan Altima (L32) 2007-2012 Service Manual ≻ Heater & air conditioning control system manual air conditioner ≻ Symptom diagnosis ≻ Noise

Nissan Altima (L32) 2007-2012 Service Manual: Noise

Component Function Check

SYMPTOM: Noise

INSPECTION FLOW

*1 HAC-102, "Operational Check"

*2 EM-16, "Checking Drive Belts" (QR25DE) or EM-121, "Checking Drive Belts" (VQ35DE)

*3 HAC-159, "Performance Chart"

*4 HA-45, "Removal and Installation for Expansion Valve"

*5 HA-35, "Removal and Installation for Compressor - QR25DE Models" or HA-36, "Removal and Installation for Compressor - VQ35DE Models"

*6 HA-35, "Removal and Installation for Compressor - QR25DE Models" or HA-36, "Removal and Installation for Compressor - VQ35DE Models"

*7 HA-21, "Maintenance of Oil Quantity in Compressor"

*8 HA-42, "Removal and Installation for Condenser"

Insufficient heating

Component Function Check SYMPTOM: Insufficient heating INSPECTION FLOW 1. CONFIRM SYMPTOM BY PERFORMING OPERATION CHECK - TEMPERATURE INCREASE 1. Turn temperature control dial clockwise to maximum ...

Precaution

Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used alon ...

Other materials:

Front and rear outboard seat-mounted side-impact supplemental air bag and roof-mounted curtain side-impact and rollover supplemental air bag systems
The side air bags are located in the outside of the seatback of the front and rear outboard seats. The curtain air bags are located in the side roof rails. All of the information, cautions and warnings in this manual must be followed. The side air bags and curtain air bags are designed to inflate i ...

System maintenance
The two radar sensors 1 for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused by objects such ...

Front power seat adjustment (if so equipped)
Operating tips The power seat motor has an auto-reset overload protection circuit. If the motor stops during operation, wait 30 seconds then reactivate the switch. Do not operate the power seat switch for a long period of time when the engine is off. This will discharge the battery. For add ...