Nissan Altima 2007-2012 Service Manual: Normal operating condition

Description

FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED)

If the engine speed is above 1,800 rpm under no load (for example, the selector lever position is neutral and engine speed is over 1,800 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies based on engine speed.

Fuel cut will be operated until the engine speed reaches 1,500 rpm, then fuel cut will be cancelled.

NOTE: This function is different from deceleration control listed under Multiport Fuel Injection (MFI) System, EC-41, "System Description".

    Engine control system symptoms
    Symptom Table SYSTEM — BASIC ENGINE CONTROL SYSTEM 1 - 6: The numbers refer to the order of inspection. (continued on next table) SYSTEM — ENGINE MECHANICAL & OTHER 1 - 6: The n ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER ...

    Other materials:

    Sunroof does not operate properly
    Diagnosis Procedure 1. CHECK BCM POWER SUPPLY AND GROUND CIRCUIT Check BCM power supply and ground circuit. Refer to BCS-42, "Diagnosis Procedure". >> GO TO 2 2. CHECK SUNROOF MOTOR ASSEMBLY POWER SUPPLY AND GROUND CIRCUIT Check sunroof motor assembly power supply and grou ...

    On-vehicle repair
    EXHAUST SYSTEM (QR25DE) Exploded View 1. RH rear muffler bracket 2. Gasket 3. Front exhaust tube 4. Ring gasket 5. Front exhaust tube hanger 6. Center exhaust tube 7. Mounting rubber 8. Center exhaust tube hanger 9. Gasket 10. Mounting rubber 11. Rear muffler 12. LH muffler tip 13. ...

    B2619 BCM
    Description BCM requests IPDM E/R to supply power to steering lock unit. After receiving the power, the steering lock unit transmits an ON signal to BCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Press the push-button ignition switc ...