Nissan Altima 2007-2012 Service Manual: On-vehicle maintenance

FRONT WHEEL HUB

Inspection

• Move wheel hub and bearing assembly in the axial direction by hand. Make sure there is no looseness of wheel bearing.

Axial end play : 0.05 mm (0.002 in) or less

• Rotate wheel hub and make sure that is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub and bearing assembly

FRONT DRIVE SHAFT

Inspection

• Check drive shaft mounting point and joint for looseness and other damage.

• Check boot for cracks and other damage. CAUTION: Replace entire drive shaft assembly when noise or vibration occur from drive shaft.

    Preparation
    Special Service Tool The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here. Commercial Service Tool ...

    Other materials:

    Warning signals
    To help prevent the vehicle from moving unexpectedly by erroneous operation of the Intelligent Key or to help prevent the vehicle from being stolen, a chime or buzzer sounds from inside and outside the vehicle and a warning is displayed in the instrument panel. When a chime or beep sounds or ...

    Stall test
    Inspection and Judgment INSPECTION 1. Inspect the amount of engine oil. Replenish the engine oil if necessary. 2. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80°C (122 to 176°F). Inspect the amount of CVT fluid. Replenish if necessary. 3. ...

    P2004 tumble control valve
    Description Tumble control valve (3) is installed in the intake manifold adapter (1). Tumble control valve actuator (2) is connected to the front end of the valve shaft. Tumble control valve actuator consists of motor and position sensor, etc. The motor opens or closes the valve by the ...