Nissan Altima 2007-2012 Service Manual: On-vehicle maintenance

PRE-INSPECTION FOR DIAGNOSTIC

Basic Inspection

1.INSPECTION START

1. Check the service history.

2. Check the following parts.

• Fuse/circuit breaker blown.

• Poor connection, open or short circuit of harness connector.

• Battery voltage.

Is the inspection result normal? YES >> Inspection End.

NO >> Repair or replace the malfunctioning parts.

    Power window lock switch does not function
    Diagnosis Procedure 1. REPLACE MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH Replace main power window and door lock/unlock switch. Refer to PWC-411, "Removal and Installation". After t ...

    On-vehicle repair
    POWER WINDOW MAIN SWITCH Removal and Installation REMOVAL 1. Remove the power window main switch finisher (2). Refer to INT-34, "Removal and Installation". 2. Power window main swit ...

    Other materials:

    Brake fluid
    Draining DRAINING CAUTION: • Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away with water immediately. • Before working, disconnect connectors of ABS actuator and electric unit (control unit) or ...

    Power generation voltage variable control system
    System Diagram System Description Power generation variable voltage control system has been adopted. By varying the voltage to the generator, engine load due to power generation of the generator is reduced and fuel consumption is decreased. NOTE: When any malfunction is detected in th ...

    Diagnosis and repair workflow
    Work Flow INTRODUCTION The TCM receives a signal from the vehicle speed sensor, PNP switch and provides shift control or lock-up control via CVT solenoid valves. The TCM also communicates with the ECM by means of a signal sent from sensing elements used with the OBD-related parts of the C ...