Nissan Altima 2007-2012 Service Manual: On-vehicle repair

POWER WINDOW MAIN SWITCH

Removal and Installation

REMOVAL

1. Remove the power window main switch finisher (2). Refer to INT-12, "Removal and Installation".

2. Power window main switch (1) is removed from power window main switch finisher (2) using a suitable tool (A).

CAUTION: Do not fold the pawl of power window main switch finisher. NOTE: The same procedure is also performed for front power window and door lock/unlock switch RH, and rear power window switch (LH & RH).

INSTALLATION

Installation is in the reverse order of removal.

    On-vehicle maintenance
    PRE-INSPECTION FOR DIAGNOSTIC Basic Inspection 1.INSPECTION START 1. Check the service history. 2. Check the following parts. • Fuse/circuit breaker blown. • Poor connection, open or s ...

    Other materials:

    P0603 ECM Power supply
    Description Battery voltage is supplied to the ECM even when the ignition switch is turned OFF for the ECM memory function of the DTC memory, the air-fuel ratio feedback compensation value memory, the idle air volume learning value memory, etc. DTC Logic DTC DETECTION LOGIC DTC CONFIRMAT ...

    Driver side
     Description Door glass moves UP/DOWN by receiving the signal from main power window and door lock/unlock switch. Component Function Check 1. CHECK POWER WINDOW MOTOR LH CIRCUIT Does power window motor LH operate with the main power window and door lock/unlock switch? Is the inspectio ...

    Hydraulic control system
    System Diagram System Description The hydraulic control mechanism consists of the oil pump directly driven by the engine, the hydraulic control valve that controls line pressure and transmission, and the input signal line. LINE PRESSURE AND SECONDARY PRESSURE CONTROL • When an input torq ...