Nissan Altima 2007-2012 Service Manual: On-vehicle repair

POWER SOCKET

Removal and Installation

FRONT POWER SOCKET

Removal

1. Remove the instrument panel storage bin or CD changer finisher (if equipped). Refer to IP-17, "Exploded View".

2. Remove the inner socket (1) from the ring (2) while pressing the hooks (B) on the ring (2) out from the square holes (A).

3. Remove ring (2) from the center console box while pressing in the pawls.

Installation

Installation is in the reverse order of removal.

CAUTION: Align the notches of the inner socket and ring with the center console box when installing.

FRONT CONSOLE POWER SOCKET

Removal

1. Disconnect the negative battery terminal.

2. Remove the center console box. Refer to IP-17, "Exploded View".

3. Remove the inner socket (1) from the ring (2) while pressing the hooks (B) on the ring (2) out from the square holes (A).

4. Remove ring (2) from the center console box while pressing in the pawls.

Installation

Installation is in the reverse order of removal.

CAUTION: Align the notches of the inner socket and ring with the center console box when installing.

    Component diagnosis
    POWER SOCKET Wiring Diagram ...

    Body control system bcm
    ...

    Other materials:

    LDW system operation
    The LDW system operates above approximately 45 MPH (70 km/h). When the vehicle approaches either the left or the right of the traveling lane, the LDW system will chime a sound and the LDW light on the instrument panel will blink to alert the driver The LDW system is not designed to operate ...

    ABS branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the ABS actuator and electric unit (control unit) for damage, bend and loose connection (unit ...

    P0139 HO2S2
    Description The heated oxygen sensor 2, after three way catalyst (manifold), monitors the oxygen level in the exhaust gas on each bank. Even if switching characteristics of the air fuel ratio (A/F) sensor 1 are shifted, the air-fuel ratio is controlled to stoichiometric, by the signal from th ...