Nissan Altima 2007-2012 Service Manual: Passenger side
Description
Door glass moves UP/DOWN by receiving the signal from main power window and door lock/unlock switch or power window and door lock/unlock switch RH.
Component Function Check
1. CHECK FRONT POWER WINDOW MOTOR RH CIRCIUT
Does front power window motor RH operate with main power window and door lock/unlock switch or power window and door lock/unlock switch? Is the inspection result normal? YES >> Front power window motor RH is OK.
NO >> Refer to PWC-116, "PASSENGER SIDE : Diagnosis Procedure".
Diagnosis Procedure
Front Power Window Motor RH Circuit Check
1. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH OUTPUT SIGNAL
1. Disconnect front power window motor RH.
2. Turn ignition switch ON.
3. Check voltage between front power window motor RH connector and ground.
Is the measurement value within the specification? YES >> GO TO 2
NO >> Replace power window and door lock/unlock switch RH. Refer to PWC-186, "Removal and Installation".
2. CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect power window and door lock/unlock switch RH.
3. Check continuity between power window and door lock/unlock switch RH connector (A) and front power window motor RH connector (B).
4. Check continuity between power window and door lock/unlock switch connector (A) and ground.
Is the inspection result normal? YES >> GO TO 3
NO >> Repair or replace harness.
3. CHECK FRONT POWER WINDOW MOTOR RH
Check front power window motor RH.
Refer to PWC-117, "PASSENGER SIDE : Component Inspection".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace front power window motor RH. Refer to GW-19, "Removal and Installation".
Component Inspection
1. CHECK FRONT POWER WINDOW MOTOR RH
Does motor operate by connecting the battery voltage directly to front power window motor RH?
Is the inspection result normal? YES >> Power window motor is OK.
NO >> Replace front power window motor RH. Refer to GW-19, "Removal and Installation".
Driver side
Description
Door glass moves UP/DOWN by receiving the signal from main power window and
door lock/unlock switch.
Component Function Check
1. CHECK FRONT POWER WINDOW MOTOR LH CIRCUIT
Does front ...
Rear LH
Description
Door glass moves UP/DOWN by receiving the signal from main power window and
door lock/unlock switch or
rear power window switch LH.
Component Function Check
1. CHECK REAR POWER ...
Other materials:
P0778 pressure control solenoid B
electrical (sec pressure solenoid
valve)
Description
The pressure control solenoid valve B (secondary pressure solenoid valve)
regulates the oil pump discharge
pressure to suit the driving condition in response to a signal sent from the TCM.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle a ...
B2110 PNP/Clutch interlock switch
Description
IPDM E/R confirms the shift position with the following signals.
• Park/neutral position (PNP) switch
• Shift position signal from BCM (CAN)
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2110 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000 ...
CSC (Concentric slave cylinder)
Exploded View
1. Transaxle assembly
2. CSC (Concentric Slave Cylinder)
Removal and Installation
CAUTION:
• If transaxle assembly is removed from the vehicle, always replace CSC. Return
CSC insert to original
position to remove transaxle assembly. Dust on clutch disc sliding parts may
...