Nissan Altima Owners Manual: Power steering fluid

Check the fluid level in the reservoir.


Check the fluid level in the reservoir.

The fluid level should be checked when the fluid is cold at fluid temperatures of 0 to 30ºC (32 to 86ºF). The fluid level can be checked with the level gauge which is attached to the cap. To check the fluid level, remove the cap. The fluid level should be between the MAX 1 and MIN 2 lines.

If the fluid is below the MIN 2 line, add Genuine NISSAN E-PSF. Remove the cap and fill through the opening.

CAUTION

● Do not overfill.

● Use of a power steering fluid other than Genuine NISSAN E-PSF will prevent the power steering system from operating properly.

● Power steering fluid is poisonous and should be stored carefully in marked containers out of the reach of children.

    Continuously Variable Transmission (CVT) fluid
    CAUTION ● Use only Genuine NISSAN CVT Fluid NS-3. Do not mix with other fluids. ● Using transmission fluid other than Genuine NISSAN CVT Fluid NS-3 will damage the CVT, which is not c ...

    Brake fluid
    For further brake fluid specification information, refer to “Capacities and recommended fuel/lubricants” in the “Technical and consumer information” section of this manual. WARNING ● ...

    Other materials:

    Tweeter (sedan)
    Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the tweeters using the audio signal circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect BOSE speaker amp. connector B122 and suspect tweet ...

    Rear window and outside mirror (if so equipped) defroster switch
    Type A To defrost the rear window glass and outside mirrors (if so equipped), start the engine and push the rear window defroster switch on. The rear window defroster indicator light on the switch comes on. Push the switch again to turn the defroster off. The rear window defroster automat ...

    None of the power windows can be operated using any switch
    Diagnosis Procedure 1. CHECK BCM POWER SUPPLY AND GROUND CIRCUIT Check BCM power supply and ground circuit. Refer to BCS-42, "Diagnosis Procedure". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the malfunctioning parts. 2. CHECK MAIN POWER ...