Nissan Altima (L32) 2007-2012 Service Manual: Service data and specifications (SDS)
Wheel Bearing
Drive Shaft
Dynamic Damper
Boot Bands
Disassembly and assembly
FRONT DRIVE SHAFT Disassembly and Assembly (Left Side) 1. Circlip 2. Dust shield 3. Slide joint housing 4. Snap ring 5. Spider assembly 6. Stopper ring 7. Boot band 8. Boot 9. Shaft 10. ...Rear axle
...Other materials:
Using the system
Initialization
When the ignition switch is in the ON position,
NISSAN Voice Recognition is initialized, which
takes a few seconds. When completed, the system
is ready to accept voice commands. If
the button is pressed before the
initialization
completes, the system will announce: “Voice
...
Crash zone sensor
Removal and Installation
REMOVAL
1. Crash zone sensor harness connector
2. Crash zone sensor
A. Crash zone sensor nuts
CAUTION:
• Before servicing, turn ignition switch OFF, disconnect both battery terminals
and wait at least three
minutes.
• Do not use air tools or electric tool ...
P0603 ECM Power supply
Description
Battery voltage is supplied to the ECM even when the ignition switch
is turned OFF for the ECM memory function of the DTC memory, the
air-fuel ratio feedback compensation value memory, the idle air volume
learning value memory, etc.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMAT ...