Nissan Altima 2007-2012 Service Manual: Side oil seal
Removal and Installation
REMOVAL
1. Remove the drive shaft. Refer to FAX-11, "Removal and Installation (Left Side)", FAX-12, "Removal and Installation (Right Side)".
2. Remove oil seal using suitable tool.
CAUTION: Do not damage the transaxle case surface when removing oil seal.
INSTALLATION
1. Drive the oil seal straight into the transaxle case and clutch housing to the specified dimension "A" using Tools.
CAUTION: Do not reuse oil seal.
2. Install the drive shaft. Refer to FAX-11, "Removal and Installation (Left Side)", FAX-12, "Removal and Installation (Right Side)".
3. Check the transaxle fluid level. Refer to TM-17, "Inspection".
Back-up lamp switch
Removal and Installation
For removal and installation of back-up lamp switch, refer to TM-28,
"Exploded View".
Inspection
• Check continuity.
...
Other materials:
Fog light switch (if so equipped)
To turn the fog lights on, turn the headlight switch
to the position, then turn the fog
light
switch to the position.
To turn the fog lights on with the headlight switch in
the AUTOposition, the headlights must be on, then
turn the fog light switch to the
position.
To turn the fog ...
Fuel pressure
Inspection
FUEL PRESSURE RELEASE
1. Turn ignition switch ON.
2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode with CONSULT-III.
3. Start engine.
4. After engine stalls, crank it 2 or 3 times to release all fuel pressure.
5. Turn ignition switch OFF.
1. Remove fuel ...
Key cylinder switch
Description
For vehicles equipped with LH and RH anti-pinch system, the main power window
and door lock/unlock switch
detects condition of the door key cylinder switch and transmits to BCM as the
LOCK or UNLOCK signal.
For vehicles equipped with LH anti-pinch system only, the door lock ass ...