Nissan Altima (L32) 2007-2012 Service Manual ≻ Ventilation system ≻ Ducts and grilles ≻ Side ventilator grilles

Nissan Altima (L32) 2007-2012 Service Manual: Side ventilator grilles

Removal and Installation

REMOVAL

Release the tabs and then remove the side ventilator grilles using a suitable tool.

CAUTION: Use a suitable tool to remove the grille to avoid damage to the instrument panel.

INSTALLATION

Installation is in the reverse order of removal.

REMOVAL

1. Remove the instrument panel. Refer to IP-12, "Removal and Installation".

2. Remove the upper ventilator duct screws using power tools.

3. Remove the upper ventilator duct.

INSTALLATION

Installation is in the reverse order of removal.

Center ventilator grilles

Removal and Installation REMOVAL Remove the center ventilator grilles (1) from the instrument panel using a suitable tool. INSTALLATION Installation is in the reverse order of removal. ...

Upper ventilator duct

Removal and Installation REMOVAL Remove the front defroster grille LH/RH from the instrument panel using a suitable tool. CAUTION: Use a suitable tool to remove the grille to avoid damage ...

Other materials:

Vehicle information display - 5 inch (13 cm) Type A (if so equipped)
The vehicle information display is located to the left of the speedometer. It displays such items as: Vehicle settings Indicators and warnings Information/warning messages Tire pressure information Drive computer information Cruise control system information Driving Aids (if so equipped) N ...

Supplemental air bag warning labels
Warning labels about the supplemental front-impact air bag system are placed in the vehicle as shown in the illustration. WARNING Do not use a rear-facing child restraint on a seat protected by an air bag in front of it. If the air bag deploys, it may cause serious injury or death. Supplemental air ...

NISSAN Intelligent Key battery discharge
If the battery of the NISSAN Intelligent Key is discharged or environmental conditions interfere with the Intelligent Key operation, start the engine according to the following procedure: 1. Place the shift lever in the P (Park) position. 2. Firmly apply the foot brake. 3. Touch the ignition switc ...