Nissan Altima Owners Manual: Spark plugs

REPLACING SPARK PLUGS


REPLACING SPARK PLUGS

Iridium-tipped spark plugs

It is not necessary to replace iridium-tipped A spark plugs as frequently as conventional type spark plugs because they last much longer. Follow the maintenance log shown in the “NISSAN Service and Maintenance Guide”. Do not service iridium-tipped spark plugs by cleaning or regapping.

● QR25DE: Always replace spark plugs with recommended ones.

● VQ35DE: Always replace spark plugs with recommended or equivalent ones

WARNING

Be sure the engine and ignition switch are off and that the parking brake is engaged securely.

CAUTION

Be sure to use the correct socket to remove the spark plugs. An incorrect socket can damage the spark plugs.

If replacement is required, see your NISSAN dealer for assistance.

    Drive belt
    QR25DE eng 1. Crankshaft pulley 2. Drive belt Automatic tensioner 3. Water pump pulley 4. Alternator 5. Air conditioner WARNING Be sure the ignition switch is placed in the OFF or LOCK posit ...

    Air cleaner
    QR25DE NOTE: The air cleaner filter should not be cleaned and reused. Replace the air cleaner filter according to the maintenance log shown in the “Warranty Information and Maintenance Bookl ...

    Other materials:

    C1708 - c1711 data from transmitter not being received
    Description Tire pressure data for one or more transmitters is not being received by the BCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.ID REGISTRATION AND VEHICLE DRIVING 1. Carry out ID registration of all transmitters. 2. Drive at a speed of 40 km/h (25 MPH) or more ...

    Charging system preliminary inspection
    Inspection Procedure 1.CHECK BATTERY TERMINALS CONNECTION Check if battery terminals are clean and tight. Is the inspection result normal? YES >> GO TO 2 NO >> Repair battery terminals connection. 2.CHECK FUSE Check for blown fuse and fusible link. Is the inspection result n ...

    Can communication circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connectors on CAN communication system. 4. Check terminals and connectors for damage, bend and loose con ...