Nissan Altima Owners Manual: Tire dressings

dressings. Tire manufacturers apply a coating to the tires to help reduce discoloration of the rubber.

If a tire dressing is applied to the tires, it may react with the coating and form a compound. This compound may come off the tire while driving and stain the vehicle paint.

If you choose to use a tire dressing, take the following precautions:

● Use a water-based tire dressing. The coating on the tire dissolves more easily than with an oil-based tire dressing.

● Apply a light coat of tire dressing to help prevent it from entering the tire tread/grooves (where it would be difficult to remove).

● Wipe off excess tire dressing using a dry towel. Make sure the tire dressing is completely removed from the tire tread/grooves.

● Allow the tire dressing to dry as recommended by the tire dressing manufacturer.

    Chrome parts
    Clean all chrome parts regularly with a nonabrasive chrome polish to maintain the finish. ...

    Cleaning interior
    Occasionally remove loose dust from the interior trim, plastic parts and seats using a vacuum cleaner or soft bristled brush. Wipe the vinyl and leather surfaces with a clean, soft cloth dampened ...

    Other materials:

    If your vehicle is stolen
    If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink®. Consult the Owner’s Manual of each device or call the manufacturer or dealer of those devices for additional information. When your vehicle is recovered, you will ...

    P0116 ECT sensor
    Description The engine coolant temperature sensor is used to detect the engine coolant temperature. The sensor modifies a voltage signal from the ECM. The modified signal returns to the ECM as the engine coolant temperature input. The sensor uses a thermistor which is sensitive to the change i ...

    P0643 Sensor power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following proced ...