Nissan Altima (L32) 2007-2012 Service Manual ≻ Audio, visual & navigation system bose audio with navigation ≻ Component diagnosis ≻ U1244 GPS antenna

Nissan Altima (L32) 2007-2012 Service Manual: U1244 GPS antenna

Description

Refer to AV-240, "System Description".

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure

1.GPS ANTENNA CHECK

Inspect GPS antenna and antenna feeder for damage or poor connection.

Is the GPS antenna and feeder clean and undamaged? YES >> GO TO 2

NO >> Repair or replace malfunctioning parts.

2.CHECK AV CONTROL UNIT VOLTAGE

1. Turn ignition switch ON.

2. Check voltage between AV control unit connector M90 terminal 73 and ground.

Is the voltage reading as specified? YES >> Replace GPS antenna. Refer to AV-447, "Removal and Installation".

NO >> Replace AV control unit. Refer to AV-437, "Removal and Installation".

U1220 AV control unit

Description Refer to AV-240, "System Description". DTC Logic DTC DETECTION LOGIC ...

U124C CD changer

Description Refer to AV-240, "System Description". DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK CD CHANGER POWER SUPPLY AND GROUND CIRCUIT Check CD changer power sup ...

Other materials:

Siri Eyes Free
Apple Siri Eyes Free personal assistant can be accessed from the vehicle. Siri Eyes Free can be accessed in Siri Eyes Free mode to reduce user distraction. In this mode, Siri Eyes Free is available for interaction by voice control. After connecting a compatible Apple device by using Bluetooth, Siri ...

Seat belt warning light and chime
The driver and front passenger seat is equipped with an enhanced seat belt reminder function. A visual and audible alert will operate at speeds of approximately 9 mph (15 km/h) or more under the following conditions: If the driver seat belt is not fastened. The front passenger’s seat belt is ...

Steering Assist temporary standby
Automatic standby due to driving operation: When the driver activates the turn signal, the Steering Assist is temporarily placed in a standby mode. (The Steering Assist restarts automatically when the operating conditions are met again.) Automatic standby: In the following cases, a warning message i ...