Nissan Altima (L32) 2007-2012 Service Manual ≻ Engine control system VQ35DE ≻ Inspection and adjustment ≻ Vin registration

Nissan Altima (L32) 2007-2012 Service Manual: Vin registration

Description

VIN Registration is an operation to register VIN in ECM. It must be performed each time ECM is replaced.

NOTE: Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M).

Special Repair Requirement

1.CHECK VIN

Check the VIN of the vehicle and note it. Refer to GI-21, "Model Variation - Coupe" or GI-20, "Model Variation - Sedan".

>> GO TO 2.

2.PERFORM VIN REGISTRATION

1. Turn ignition switch ON and engine stopped.

2. Select “VIN REGISTRATION” in “WORK SUPPORT” mode.

3. Follow the instruction of CONSULT-III display.

>> END

Ignition timing

Description This describes how to check the ignition timing. For the actual procedure, follow the instructions in “BASIC INSPECTION”. Special Repair Requirement 1.CHECK IGNITION TIMIN ...

Accelerator pedal released position learning

Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sens ...

Other materials:

Jacking up vehicle and replacing the damaged tire (AWD models)
WARNING For AWD vehicles - the TEMPORARY USE ONLY spare tire must be installed to the rear wheels only. If a front tire is punctured, install the original rear tire onto the front wheel, then install the TEMPORARY USE ONLY spare tire on the rear. Failure to do so could cause overheating to the AWD ...

Exhaust gas (carbon monoxide)
WARNING Do not breathe exhaust gases; they contain colorless and odorless carbon monoxide. Carbon monoxide is dangerous. It can cause unconsciousness or death. If you suspect that exhaust fumes are entering the vehicle, drive with all windows fully open, and have the vehicle inspected imme ...

Cleaning interior
Occasionally remove loose dust from the interior trim, plastic parts and seats using a vacuum cleaner or soft bristled brush. Wipe the vinyl and leather (if so equipped) surfaces with a clean, soft cloth dampened in mild soap solution, then wipe clean with a dry, soft cloth. Regular care and cleani ...