Nissan Altima (L32) 2007-2012 Service Manual: A-BAG branch line circuit
Diagnosis Procedure
1.CHECK AIR BAG DIAGNOSIS SENSOR UNIT
Check the air bag diagnosis sensor unit. Refer to SRC-3, "Work Flow".
Is the inspection result normal?
YES >> Replace the main harness.
NO >> Replace parts whose air bag system has a malfunction.
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and co ...
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the BCM for damage, ...
Other materials: System maintenance
The two radar sensors 1 for the BSW and
RCTA systems are located near the rear
bumper. Always keep the area near the radar
sensors clean.
The radar sensors may be blocked by temporary
ambient conditions such as splashing
water, mist or fog.
The blocked condition may also be caused
by objects such ...
Turning the RAB system on/off
For vehicles with the 7 inch (18 cm) display
Perform the following steps to turn the RAB
system ON or OFF.
For vehicles with the 7 inch (18 cm) display.
1. Press thebutton until
"Settings" displays
in the vehicle information display.
Use thebutton to select "Driver
Assistance."
Then press the OK ...
Active noise cancellation/Active sound
enhancement (if so equipped)
Active noise cancellation
Front Microphone
This system uses microphones 1 located
inside the vehicle to detect engine booming
noise. The system then automatically generates
a noise cancelling sound through the
speakers and woofer (if so equipped) to reduce
engine booming noise.
NOTE:
To operate the ...