Nissan Altima 2007-2012 Service Manual: Additional service when removing battery negative terminal
Description
Initial setting is necessary when battery terminal is diconnected.
CAUTION: The following specified operations are not performed under the non-initialized condition.
• Auto-up operation
• Anti-pinch function
• Retained power operation
Special Repair Requirement
INITIALIZATION PROCEDURE
1. Disconnect battery negative terminal or main power window and door lock/unlock switch. Reconnect it after a minute or more.
2. Turn ignition switch ON.
3. Operate power window switch to fully open the window. (This operation is unnecessary if the window is already fully open) 4. Continue pulling the power window switch UP (AUTO-UP operation). Even after glass stops at fully closed position, keep pulling the switch for 4 seconds or more.
5. Inspect anti-pinch function.
CHECK ANTI-PINCH FUNCTION
1. Fully open the door window.
2. Place a piece of wood near fully closed position.
3. Close door glass completely with AUTO-UP.
• Check that glass lowers for approximately 150 mm or 2 seconds without pinching piece of wood and stops.
• Check that glass does not rise when operating the power window main switch while lowering.
CAUTION: • Do not check with hands and other part of body because they may be pinched. Do not get pinched.
• Check that AUTO-UP operates before inspection when system initialization is performed.
• It may switch to fail-safe mode if open/close operation is performed continuously. Perform initial setting in that situation. Refer to PWC-229, "Fail Safe".
• Perform initial setting when auto-up operation or anti-pinch function does not operate normally.
• Finish initial setting. Otherwise, next operation cannot be done.
1. Auto-up operation
2. Anti-pinch function
3. Retained power operation when ignition switch is OFF.
Additional service when replacing
control unit
Description
Initial setting is necessary when replacing main power window and door
lock/unlock switch.
CAUTION:
The following specified operations are not performed under the non-initial ...
Other materials:
Rear combination lamp
Bulb Replacement
Removal
1. Remove the rear combination lamp. Refer to EXL-260, "Removal and
Installation".
2. Turn the rear turn signal lamp bulb socket counterclockwise and remove it.
3. Remove the rear turn signal lamp bulb.
Installation
Installation is in the reverse order ...
Combination meter
Reference Value
TERMINAL LAYOUT
PHYSICAL VALUES
Wiring Diagram - Coupe
Wiring Diagram - Sedan
Fail Safe
The combination meter performs a fail-safe operation for the functions listed
below when communication is
lost ...
On board refueling vapor recovery
(ORVR)
Description
From the beginning of refueling, the air and vapor inside the fuel tank go
through refueling EVAP vapor cut
valve and EVAP/ORVR line to the EVAP canister. The vapor is absorbed by the EVAP
canister and the air is
released to the atmosphere.
When the refueling has reached the ...