Nissan Altima 2007-2012 Service Manual: Additional service when replacing control unit

 Description

Initial setting is necessary when replacing main power window and door lock/unlock switch.

CAUTION: The following specified operations are not performed under the non-initialized condition.

• Auto-up operation

• Anti-pinch function

• Retained power operation

Special Repair Requirement

INITIALIZATION PROCEDURE

1. Disconnect battery negative terminal or main power window and door lock/unlock switch. Reconnect it after a minute or more.

2. Turn ignition switch ON.

3. Operate power window switch to fully open the window. (This operation is unnecessary if the window is already fully open) 4. Continue pulling the power window switch UP (AUTO-UP operation). Even after glass stops at fully closed position, keep pulling the switch for 4 seconds or more.

5. Inspect anti-pinch function.

CHECK ANTI-PINCH FUNCTION

1. Fully open the door window.

2. Place a piece of wood near fully closed position.

3. Close door glass completely with AUTO-UP.

• Check that glass lowers for approximately 150 mm or 2 seconds without pinching piece of wood and stops.

• Check that glass does not rise when operating the main power window and door lock/unlock switch while lowering.

CAUTION: • Do not check with hands and other part of body because they may be pinched. Do not get pinched.

• Check that AUTO-UP operates before inspection when system initialization is performed.

• It may switch to fail-safe mode if open/close operation is performed continuously. Perform initial setting in that situation. Refer to PWC-229, "Fail Safe".

• Perform initial setting when auto-up operation or anti-pinch function does not operate normally.

• Finish initial setting. Otherwise, next operation cannot be done.

1. Auto-up operation

2. Anti-pinch function

3. Retained power operation when ignition switch is OFF.

    Additional service when removing battery negative terminal
     Description Initial setting is necessary when battery terminal is diconnected. CAUTION: The following specified operations are not performed under the non-initialized condition. • Aut ...

    Other materials:

    M/T Oil
    Draining 1. Start engine and let it run to warm up transaxle oil. 2. Stop engine and remove the drain plug to drain the oil. 3. Install the drain plug with a new gasket to the transaxle case. Tighten the drain plug to the specified torque. Refer to TM-79, "Exploded View". CAUTIO ...

    B26e1 no reception of engine status signal
    Description BCM receives the engine status signal from ECM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26E1 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-36, "DTC Logic". • If DTC B26E1 is displayed wit ...

    Radiator
    Removal and Installation 1. Radiator 2. CVT oil cooler hose (if equipped) 3. Radiator hose (upper) 4. Radiator hose (lower) 5. Cooling fan 6. Reservoir tank 7. Reservoir hose 8. Radiator filler cap 9. Clamps A. To CVT (if equipped) B. To water outlet C. To water inlet WARNING: Never ...