Nissan Altima (L32) 2007-2012 Service Manual: Ambient sensor
Removal and Installation
REMOVAL
1. From under the vehicle, disconnect the ambient sensor connector
(2).
2. Release the ambient sensor clip and remove the ambient sensor
(1).
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation for Condenser
REMOVAL
1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service
Procedure".
2. Remove the front fascia (coupe only). Refer to E ...
Removal and Installation for Refrigerant Pressure
Sensor
REMOVAL
1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service
Procedure".
2. Remove the front grille. Ref ...
Other materials: MOD system limitations
WARNING
Listed below are the system limitations
for MOD. Failure to operate the vehicle
in accordance with these system limitations
could result in serious injury or
death.
Do not use the MOD system when
towing a trailer. The system may not
function properly.
Excessive noise (for example, audio ...
Active noise cancellation/Active sound
enhancement (if so equipped)
Active noise cancellation
Front Microphone
This system uses microphones 1 located
inside the vehicle to detect engine booming
noise. The system then automatically generates
a noise cancelling sound through the
speakers and woofer (if so equipped) to reduce
engine booming noise.
NOTE:
To operate the ...
Engine compartment check locations
2.0L 4 cylinder (KR20DDET engine model)
Engine coolant reservoir
Drive belt location
Engine oil filler cap
Brake fluid reservoir
Battery
Fuse/Fusible link box
Air cleaner
Radiator cap
Engine oil dipstick
Windshield-washer fluid reservoir
Refer to the page number indicated in
parenth ...