Nissan Altima (L32) 2007-2012 Service Manual: Anti-pinch system does not operate
normally (driver side)
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-108, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. CHECK DOOR WINDOW SLIDING PART
• A foreign material adheres to window glass or glass run rubber.
• Glass run rubber wear or deformation.
• Sash is tilted too much or not enough.
Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace the malfunctioning parts.
3. CHECK ENCODER CIRCUIT
Check encoder circuit.
Refer to PWC-103, "POWER WINDOW MAIN SWITCH : Component Function Check".
Is the inspection result normal?
YES >> Inspection end.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1. CHECK REAR POWER WINDOW SWITCH RH
Check rear power winodw switch RH.
Refer to PWC-110, "REAR POWER WINDOW SWITCH : Component Function Check".
Is the inspection ...
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-108, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".
Is the inspectio ...
Other materials: Readiness for Inspection/Maintenance (I/M)
test
WARNING
A vehicle equipped with All-Wheel Drive
(AWD) should never be tested using a
two wheel dynamometer (such as the
dynamometers used by some states
for emissions testing), or similar equipment.
Make sure you inform the test
facility personnel that your vehicle is
equipped with AWD before it is ...
Difference between predicted and
actual distances
The displayed guidelines and their locations
on the ground are for approximate
reference only. Objects on uphill or downhill
surfaces or projecting objects will be actually
located at distances different from
those displayed in the monitor relative to
the guidelines (refer to illustrations). When
in ...
Vehicle information display warnings
and indicators
The following messages may appear in
your vehicle information display.
Place the key near the start
switch
This indicator appears when the battery of
the Intelligent Key is low and when the Intelligent
Key system and the vehicle are not
communicating normally.
If this appears, touch the ignition s ...