Nissan Altima (L32) 2007-2012 Service Manual: Auto operation does not operate
but manual operates normally
(driver side)
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-108, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. CHECK ENCODER
Check encoder.
Refer to PWC-103, "POWER WINDOW MAIN SWITCH : Component Function Check".
Is the inspection result normal?
YES >> Inspection end.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-108, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".
Is the inspection ...
Diagnosis Procedure
1. CHECK FRONT DOOR SWITCH
Check front door switch.
Refer to PWC-124, "Component Function Check".
Is the inspection result normal?
YES >> Inspection end.
...
Other materials: USB (Universal Serial Bus) Connection
Port
Type-A.
Connecting a device to the USB
Connection Port
WARNING
Do not connect, disconnect, or operate
the USB device while driving. Doing so
can be a distraction. If distracted you
could lose control of your vehicle and
cause an accident or serious injury.
CAUTION
To avoid damage and loss of f ...
Precautions on child restraints
WARNING
Failure to follow the warnings and instructions
for proper use and installation
of child restraints could result in serious
injury or death of a child or other
passengers in a sudden stop or collision:
The child restraint must be used
and installed properly. Always follow
all of ...
I-FCW system limitations
Illustration A
Illustration B
WARNING
Listed below are the system limitations
for the I-FCW system. Failure to operate
the vehicle in accordance with these
system limitations could result in serious
injury or death.
The I-FCW system cannot detect all
vehicles under all conditions.
The radar se ...
Anti-pinch system does not operate
normally (driver side)
Power window retained power operation
does not operate properly