Nissan Altima (L32) 2007-2012 Service Manual: Anti-pinch system does not operate
normally (passenger side)
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. CHECK DOOR WINDOW SLIDING PART
• A foreign material adheres to window glass or glass run rubber.
• Glass run rubber wear or deformation.
• Sash is tilted too much or not enough.
Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace the malfunctioning parts.
3. CHECK ENCODER CIRCUIT
Check encoder circuit.
Refer to PWC-208, "PASSENGER SIDE : Component Function Check".
Is the inspection result normal?
YES >> Inspection End.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement&qu ...
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement&qu ...
Other materials: System temporarily unavailable
For vehicles with the 7 inch (18 cm) display
When radar blockage is detected, the system
will be deactivated automatically. The
"Unavailable: Side Radar Obstruction"
warning message will appear in the vehicle
information display.
The systems are not available until the
conditions no longer exist.
...
Cruise control operations
The cruise control allows driving at a speed
between 25 - 89 mph (40 - 144 km/h) without
keeping your foot on the accelerator
pedal.
To turn on the cruise control, push the
cruise control switch on. The
indicator
in the instrument panel will illuminate.
To set cruising speed, accelerate the veh ...
Programming trouble-diagnosis
If the HomeLink does not quickly learn the
hand-held transmitter information:
Replace the hand-held transmitter batteries
with new batteries.
Position the hand-held transmitter with
its battery area facing away from the
HomeLink surface.
Press and hold both the HomeLink and
hand-held transmi ...